General discussion

Locked

New GSNW for NW 5.0?

By mossing ·
Hello,

I have had access problems from my NT to NW 5.x servers, since making the switch on th elater. The GSNW is set up properly on both sides, but I can't access folders/files.

Does anyone know anything a bout a new (rumored) GSNW for NT toNW 5.x?

Thanks!!

MikeO

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

New GSNW for NW 5.0?

by mike In reply to New GSNW for NW 5.0?

Mike there is NOT an upadted GSNW for 5.X I had a similar problem that was driving me nuts. It turned out depending on the install method that the GWSN "Appeared" to be installed correctly but was not, it ended up being that occasionally the IPX would not be configured/bound correctly.(if installed) If NW is running IP Remove ALL nt protocols, (not the nic drive), reboot re-install IP then re-boot. Re-install GWSN w/o IPX re-boot then re-apply the lates service pack. This is a full proof wayof getting it working. I've seen some pretty quarky stuff with MS's GWSN but hey once you get it working it's fine!!!
Good Luck
Mike

Collapse -

New GSNW for NW 5.0?

by mossing In reply to New GSNW for NW 5.0?

The question was auto-closed by TechRepublic

Collapse -

New GSNW for NW 5.0?

by Conrad In reply to New GSNW for NW 5.0?

I not only use all the brains that I have but all that I can borrow.

--Woodrow Wilson

Collapse -

New GSNW for NW 5.0?

by mossing In reply to New GSNW for NW 5.0?

The question was auto-closed by TechRepublic

Collapse -

New GSNW for NW 5.0?

by mossing In reply to New GSNW for NW 5.0?

This question was auto closed due to inactivity

Back to Windows Forum
5 total posts (Page 1 of 1)  

Related Discussions

Related Forums