Question Locked

New Video card for Compaq Deskpro EN doesn't work

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Compaq Deskpro EN 133HZ, Pentium III machine running Windows 2000 Professional. It has an onboard VGA input. I recently upgraded the memory to 256. I just purchased a Diamond Stealth ATI Radeon 9250 PCI video card. My machine fits all the minimum system requirements of the card.

When I start my PC, I do not get any display.

When I swap my VGA plus back to the onboard port, I don't get any display either.

I've tried disabling the onboard VGA port in BIOS, but am not 100% sure where that might be; let's just say the bios is pretty simple and doesn't seem to have this kind of detail. I've tried reseating the video card multiple times. I can plug a NIC into the same PCI slot and it works, so it's not an issue with the PCI slot. I've also tested the S-Video output to my TV, to see if it was an issue with the VGA port on the card, but that didn't work either.

I am completely out of ideas. Any suggestions?

4 replies

by robo_dev

Or they don't work at the same time?

You cannot disable the onboard video on those compaqs. There may be issues because that machine was waay back in the day of the old PCI standards, and that card is about 14 years newer technology, and newer PCI standards are now in effect. It's also remotely possible that the power supply cannot supply enough power, but I doubt it.

I don't mean to 'dis' your system, but putting a Radeon 9250 in there is like putting a 747 engine in a 74 Ford Pinto.

by Former member

Do you get the "bios" screen, or can you access it when you bootup? If you can not then just locate the little battery that is on the motherboard and (PLEASE WEAR A STATIC WRIST STRAP)remove it, wait for 15 to 20 seconds and then replace it, restart and then access your "bios" to check if all is well with your hdd's and on board vga. Another thing is to disable the on board graphics in the "bios" so that your new graphic card does not crash with the on board vga of which sounds has happened.

Please post back if you have anymore problems or questions.

by oh smeg

This is a very common occurrence with AMD Computers as there is a Chip Set Incompatibility between the M'Board Chip Set and the Video Card Chip Set which prevents the computer booting.

But it may not be the case here if you are hearing anything like the Beeps as the System POSTS or Windows Opening.

If the screen remains blank and there is no noise you have a Chip Set Incompatibility and need to change either the Video Card or M'Board.

Sometimes with problems like this just moving to a different Maker with the Same Chip Set is sufficient but other times you need to go to either a Different Chip Set completely or a Different Maker. So if you have the same problem with the Same Chip Set Video Card from a different Maker you need to try a different Chip Set Card and if that doesn't work [i] and there are quite a few different makers who use the entire ATI range of Chip Sets[/i] you need to go to a Different Chip Set Maker which in this case is NVidia.

While not so common with Intel Computers because of the age difference between the M'Board and Video Card it's the most likely problem.

Col

This discussion is closed to new replies.