Discussion Locked

nic card works in 98/not in win2kpro

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to get a trendware te100-pciwa/n
working in pro,there are no resource conflicts.I have the latest drivers,and the nic is on the hcl for pro,but it wont send or recieve. works in win98.Sure would appreciate a fix here,thanks.

8 replies

by computechie

If your NIC is showing up in the Device Manager and has no conflicts and your using a Win2000 driver, I would check under the My Network Places properties, then right click on Local Area Connection. You can actually disable and enable a network cardthere, make sure yours is enabled. Also go to the same Local Area Connection, and make sure you have all the protocols you need there, and that they are bound to the NIC. Also click on the status option and see that it is connected to your hub or whatever your connecting it too. Hope this helps you solve your problem.

by petemcc

You probably tried this already, but I had problems with a realtek compatible NIC, finally physically and logically removed it, reinstalled, and AOK from there, and does it work with netbeui?

by dhuggin1

Thanks for trying,but i did indeed try removing it and reinstalling it. No luck at all.

by drdon

Since you have done all the basic troubleshooting, I would look look in Device Manger to be sure the NIC is fine. Next with TCPIP bound, can you ping its self using the assigned IP address? If no, can you ping the internal loop back? If you can ping the IP of the NIC, can you ping the router? If so, you should be able then to continue. If not, look at the cabel and connections to the switch/hub you are in.

Next, browse the network and see if any computers are near me. Then see if you can attach to one.

Just a few starting points. HTH

by dhuggin1

Thanks for trying,but no help.I have already tried pinging it from other pc's and the loopback..You see the out link light is on but not the incoming link light.

by peggyellis

I had the same problem with a RealTek NIC, took it back to the store, they replaced it with the newer model and it worked, They both claimed they were compatible with W98 and NT. Neither said specifically W2k. Maybe you should try another card and see what happens.

Hope this helps

by dhuggin1

Thankyou for trying. but you see i am a dealer,so i cant take it back. I buy wholesale,they frown on returns of this nature,when i could sell it to someone else. And anyway i have tried two other realtek nic's,one is a trenware nic with a realtek chip.

This discussion is closed to new replies.