Discussion Locked

No Access to Shared Printer

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm currently upgrading desktop systems from W98SE to WinXP Pro. After the upgrade, some machines won't print to an HP LJ 1000 that's connected to the network via the parallel port on another W98SE machine. These PCs accessed that printer fine prior to upgrading. There doesn't "seem" to be any rhyme or reason why some PCs will connect OK after the upgrade while others won't, except that the one's that WILL are all connected via a LAN Manager Printer Port vs a Local Port. (The latter is Microsoft's recommended configuration for an XP machine connecting to a network printer; i.e., use the printer's network UNC name as the name of the Local Port.) However, I'm unable to force the acceptance of a LAN Manager Printer Port over a Local Port. The best success I've had is to uninstall the printer prior to upgrading, then reinstall, but even that doesn't work every time. This issue stumped both HP & Microsoft.

5 replies

by shaunjanzen

Check your advanced TCP/IP settings under the WINS tab on the XP machines and make sure that the "Enable NetBIOS over TCP/IP" is selected. If that does not work try and connect to the printer using the IP address instead ( \\IPaddress of PrintServer\printer_sharename)

by lablue

The TCP/IP settings were already correct, but your second suggestion about using the IP address instead of the computer name did the trick, at least on all of my upgraded machines so far! As I progress with the upgrades, I'll see if this technique holds true across the board. But for now, I'm back in business!!! Thanks for the bailout!!

by vernmathews

Upgrade the machine that has the printer on it to XP Pro. I have seen almost the exact same problem with mixing NT & XP Pro machines while trying to share printers. You might see simular problems while trying to share files with the mixed operating systems. Hope that this helps!

by lablue

I appreciate the advice, but there's a specific reason why I can't upgrade the PC the printer is attached to. We have some legacy software that won't run on XP. Thanks, anyway!

This discussion is closed to new replies.