Question Locked

No reaction on power up

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Yesterday I installed some new components in my pc.

I switched on the power, all worked fine until a restart. Then the pc is not responding. Mobo light is lit, also HDD led works, but no POST beep or booting sequence. Also the screen of my pc stays black.

I think my Power Supply is somewhat malfunctioning, but it easily could be the mobo.

Any comments on this?

Specs I installed:

- Intel C2D 6750
- Asus P5N-E SLI Mobo
- 500W Antec power supply
- 2 GB Kingston DDR-2 800 Mhz

3 replies

by ryan

same prob here

same mobo
same cpu
and my ram is g.skill 2gb (2x 1gb sticks, one stick is installed though)
500w rosewill LED PSU

i hope its the PSU and not the mobo , any help would be appreciated .. thanks..

Ryan

by robo_dev

PS/memory/processor/MOBO

Unplug everything from the mobo except the processor and power supply and pull out the memory. Short the power-sw jumpers briefly.

A normal mobo would give you lots of beeps complaining about not having memory, etc.

if no beep codes when you attempt this, then it's the mobo or PS.

Clear the cmos and try again. If a known-good PS has the same result, then it's the mobo or processor. I've never seen a processor fail, so I would guess mobo.

- Make sure mobo is not shorting to case
- check your jumpers.
-unplug and reseat the power supply connector to the mobo. Check for bent or damaged PS connector pins on both the mobo and the PS.

-If there are any socketed devices on the mobo, press them firmly to make sure they are seated correctly.

-Sniff for any smell of burnt components and look for cracked or damaged components or solder traces

-Make sure processor fan is functional and connected properly.

This discussion is closed to new replies.