General discussion

Locked

NT 4 and large hard disks

By djf ·
I am setting up an NT 4 BDC that will eventually replace the current PDC. This BDC has two 40 GIG hard disks, but NT 4 reads them as 8 GIG. I plan to reinstall NT to get these reconfigured correctly, but am not sure how to go about that. Any advice is appreciated!

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

NT 4 and large hard disks

by dmiles In reply to NT 4 and large hard disks

Apperently the machines need to be updated by flashing the bios,note the bios version and manufacturer during the POST startup and go to manufacturer site for update.
Then look at the Microsoft knowledgebase and ref the download to ATAPI,which you will need to install,with service pack 6 for NT,to gain large disk support

Collapse -

NT 4 and large hard disks

by djf In reply to NT 4 and large hard disks

Poster rated this answer

Collapse -

NT 4 and large hard disks

by djf In reply to NT 4 and large hard disks

This question was closed by the author

Back to Networks Forum
3 total posts (Page 1 of 1)  

Related Forums