General discussion

Locked

NT 4.0 and Fixed Hard disks

By anthony.robinson ·
I have a Netfinity 5000 Server which has NT 4.0 installed and SP6a. My question is this:
I do not know why when this sever warm boots only 2 out of 3 Fixed disks are seen by NT. But if I cold boot this sever all 3 fixed disks are seen by NT. I checked the BIOS and it is setup correctly. I also watched POST and it shows all 3 drives. By the way, all three Fixed Disks are SCSI. I am puzzled because it works in cold boots but not warm boots. Can someone help me with this problem.

This conversation is currently closed to new comments.

2 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

NT 4.0 and Fixed Hard disks

by mgonzales In reply to NT 4.0 and Fixed Hard dis ...

I'v had this problem with a compaq....I ended up performing a firmware upgrade for the RAID card...you might want to look into that....also check out IBM website for info on this problem...

Good Luck!

Collapse -

NT 4.0 and Fixed Hard disks

by Shanghai Sam In reply to NT 4.0 and Fixed Hard dis ...

check the and make sure that only the last
drive has termination on. disable termination
on the other two drives. It sounds like you are having a scsi terminiation problem.

Back to Windows Forum
2 total posts (Page 1 of 1)  

Related Forums