Windows Forum

Ask something
Discussion Locked

nt4.0 event viewer

0 helpful
5 replies

by msfiroudis

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Under windows nt4.0 in a lan environment..
In the system event viewer.. I get a message of the following: "An unexpected network error has occured on the virtual circuit to (here would be the user's name)"..What does this message mean..Any help would be appreciated.........

5 replies

by istech

When data goes back and forthe over your network, it's causing the virtual circuit error.
Check your network connections. (cables, switches, hubs)
Updating or downgrading your NIC drivers can also help.
Hope this helps. Good luck

by magetower

Make sure the following is the same accross your network:

1. The network settings for speed (10Mb or 100Mb)and duplex (full/half) on switch/hub ports and connected workstation NICs match.

2. All routers are supporting the same protocols and routing information.

3. The correct cabling is in use.

If this is consistantly occuring from a specific workstation, check the NIC on that system. If it is a specific user then see if that user is running something that is network intensive.

This discussion is closed to new replies.