General discussion

Locked

P IV boot failure

By madanmule ·
we have PIV with 40 GB seagate HDD ST320410A is detected in CMOS setup,but it dosent boot,we had tried DM 6 still it dosent boot,& for Fdisk it says No fixed disk found.
Please help out of this situation.

This conversation is currently closed to new comments.

2 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by HAL 9000 Moderator In reply to P IV boot failure

Are you sure that is the right model number? According to the Seagate Web Site it is a 20.4 GIG drive. See here

http://www.seagate.com/support/disc/specs/ata/st320410a.html

Anyway you can find the install process at

http://www.seagate.com/support/disc/iguides/ata/u6ig100129587b.pdf

Col

Collapse -

by dmiles In reply to P IV boot failure

1)Check the Seagate site for drive diagnostic tool,to run on drive

2)Check the cable on system if case has been opened recently

3)Make sure that you have the drive formatted and partitioned with operating system installed

You can also try updating the bios to system

Back to Hardware Forum
2 total posts (Page 1 of 1)  

Related Discussions

Related Forums