Discussion Locked

Pagefile.sys upon reboot changes to 20MB

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Win2k VPN and file server:
Upon rebooting, error message indicates the pagefile.sys is corrupt or missing and Win2k has set up a temporary paging file of 20 MB.
Reseting this option, is temporary until the next user logs on.
Any ideas or fixes would be appreciated.
Thanks,
J

7 replies

by cavedweller

You might have a bad disk. Go to the system settings and manually specify an alternate pagefile.sys location. Reboot the system and see if you get the same error message. This should either get you going or help debug the problem.

by jlyons

I had performed a scan initially to verify integrity and all disks came up clean.
Had allocated same size pagefile to another drive and still received the same error message. Thanks for your suggestions

by satyre

Check to make sure you have enough free disk space and then go into System Properties -> Advanced -> Performance Options and click on change. Make sure you set the page file after telling it what size it is.

If that doesn't work, try setting it to 0 and reboot, then change it back to the amount you want and reboot again and see if that fixes it.

by jlyons

Tried resetting the pagefile to zero per a discussion with Dell tech support and, unfortunately, it still chose 20 MB as the default. Thanks for your help.

by j_o_blair

note about answer three- be careful setting the page file to zero... have had it happen that the machine will not boot at all

by jlyons

Was aware of resetting pagefile to zero but needed to give it a shot. It still rebooted but with only 20MB in the sys file.
Tracked down a concurrent problem with installing sp3 and it's apparent corruption of the M$ Installer. Not only was the pagefile corrupt but we could no longer install or uninstall any programs. We suspected a virus but scans came up clean. The server has been rebuilt due to lack of adaquate time to resolve the issue through discovery. Thanks for your help

This discussion is closed to new replies.