Discussion Locked

pages to large for monitor

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My father-in-law just upgraded to Windows 98 and now all his windows are to large for his monitor. He has a 17" gateway monitor. I went to the control panel/display/settings and adjusted the screen pixel size. This did reduce the page images but the page in full still goes off the screen where you cannot see the three top right boxes, or the scroll bar. I cannot hold and drag it t the left to see them either. I was wondering what can be done to get the window pages to fit the monitor correctly? Look forward to suggestions. The computer is a Pentium 2.

6 replies

by timthetoolman

The new display drivers in Win98 are causing the problems. I've seen different OS'd display differently on the screen - size wise.

I especially had this problem with Linux and Windows. Linux pushed it off to the left and so I had to compromise with a somewhat leftish Linux and Rightish windows...

Make sure you have the latest drivers from your video card - they're downloadable from the manufacturer's website and if this doesn't fix the problem...

then you'll have to adjust the screen size on your monitor. Pretty much all monitors have adjustment buttons where you can increase/decrease the height and width of the display. Also pin cusion effect, skew and a whole bunch of adjustments.

...but make sure you have up to date drivers first.

Cheers,
Tim.

by fenaikh

Hi

Use the adjustments for the horizontal and vertical size of the image on the monitor.
The video driver and the screen resolution also has an impact on image size and could be adjusted by the configuration utility that came with your video driver.Adjust the size and position of the image and then change the screen resolution.
Dwonload the latest driver for the diplsy card and make sure you slect the right montor type too.
If all this did not work take the monitor to a repair shop for adjustment.
Good luck

Mohamed

by fenaikh

Hi

Pls do not try to open it up. There are very high voltages present in monitors, and it is not worth the risk of injury to work on a monitor yourself. Take it to a workshop.

Good luck

Mohamed

This discussion is closed to new replies.