Question

Locked

PIX501 VPN Tunnel question

By mtucker1975 ·
What are the commands to setup an VPN tunnel with the following constraints. I have been trying to do this through the gui interface and have not been successful. I also cannot ping outside my PIX501. It connects to the internet and is able to ping inside the internal network. Here are my constraints -
Remote endpoint is: 66.179.80.108
Remote internal network is: 192.168.50.0 (255.255.255.0)
Internal network will need to make ACL from 172.28.43.8 to host 192.168.50.83 and 192.168.50.86
Internal network will need to NAT interesting traffic to 172.28.43.0 255.255.255.0
Internal network end point is:66.137.84.121
Internal network: 192.168.10.0
Phase 1
Authentication: Pre-Shared
Encryption: 3DES
Hash: SHA
DH: 1
Lifetime: 86400 sec
Phase2
ESP encryption 3DES
ESP authentication SHA 1
Lifetime 28800
No PFS
Please help.

This conversation is currently closed to new comments.

2 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Collapse -

Cisco Vpn

by adrian In reply to PIX501 VPN Tunnel questio ...

Hey Body did you ever get this figured out?
as I am trying to setup EMDS on a Cisco aswell and My tech guys are hitting brick walls.

How did you fair? we can help eachother

Collapse -

Allow any any port 1723 & GRE 47

by CG IT In reply to PIX501 VPN Tunnel questio ...

is your PIX going to act as the VPN endpoint and also your authentication point?

you need DHCP relay agent or some relay agent plus a static pool of local LAN addresses to provide local LAN access to resources.

Back to Networks Forum
2 total posts (Page 1 of 1)  

Related Discussions

Related Forums