Discussion Locked

policy

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
after setting all policies on a pc, then running sysprep. I then place that build onto a new pc the policies are enabled but not pulled through. i.e I logon as a user and for instance the RUN command is still usable by that user, even though it is enabled in GPCONSOLE?

6 replies

by curlergirl

Are you on a domain? If there are default domain policies in place, I believe they take precedence over local policies. So, if you are on a domain you need to enable and set those policies at the domain level. Hope this helps!

by dlee

yes we are on a domain. But there are no default domain policies in place.

by pete.cook

If you are on a domain then you have default policies in place, you may not have altered them. A way to check that policies are being overidden is to open a mmc and select the snap-in for group policy. This will provide you with an option as to which computer you wish to check. Select the local pc. Any settings you view will have the local setting and an effective setting. The effective setting is usually from the dc. If that is the case then alter the settings from the domain policy (admin tools).
Remember you can force policy updates with secedit. Hope it helps.

This discussion is closed to new replies.