General discussion



By siya_stc ·
i have a problem with my printer...

it is dot matrix printer...

printer is used daily, but now i have problem of printer...

printer is configured correctly...

and there is proper power supply to printer and also sensing the paper...

but not printing...

just before that i replaced the motherboard because of the problem in mother board...

but other printers are printing in the motherboard...

i changed the data cabel and power cabel also, there is no printing..

and my os is windowsxp and there is no problem with the port of
mother board also...

whats the solution to print...

printer is epsonLQ1150+

This conversation is currently closed to new comments.

2 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by BFilmFan In reply to printer

First check your printer driver. Drivers are available here:

Then check to see if your printer port is set to bi-directional printing. As I recall, that Epson did function with bi-directional printer control.

Also check the printer cable. I have seen printer cables go bad in the past.

Product specifications are also available off that link too.

Collapse -

by glyall In reply to printer

try stopping the print spooler service than restart it.
reboots do not fix the problem.

in XP from the Start > Run command enter

Good Luck

Back to Hardware Forum
2 total posts (Page 1 of 1)  

Related Discussions

Related Forums