General discussion

  • Creator
    Topic
  • #2130427

    Printer Problem WithX.P.

    Locked

    by dr_d_ ·

    I have a lexmark Z11 printer woked fine went from M.E. to X.p. updated drivers for ntfs it reads it loads files to Que and prints half sometimes not at all and sometimes at next restart.

All Comments

  • Author
    Replies
    • #3549550

      Printer Problem WithX.P.

      by dr_d_ ·

      In reply to Printer Problem WithX.P.

      Point value changed by question poster.

    • #3548522

      Printer Problem WithX.P.

      by roadrunnerchaser ·

      In reply to Printer Problem WithX.P.

      sounds silly and simple but 9/10 times it works.

      Remove the printer physicaly from your pc.
      Uninstall the printer software from the contol panel if it is there (add remove software) then remove the printer. Reboot.
      IF USB plug the printer in while xp is running. It will locate it, install it and set it up.
      If parallel, turn off pc, install cable and turn on the printer. start pc and open xp/administrator. it should find the printer and load, install, and set it up.

      All this will only work properly if your Printer is located on the HCL for XP. this can be identified on Microsofts website or on your installation media kit (cdrom)

      • #3569311

        Printer Problem WithX.P.

        by dr_d_ ·

        In reply to Printer Problem WithX.P.

        nice try but it still has a glitch
        it sends out blank sheets now thanx.

    • #3569308

      Printer Problem WithX.P.

      by dr_d_ ·

      In reply to Printer Problem WithX.P.

      Point value changed by question poster.

    • #3549078

      Printer Problem WithX.P.

      by dr_d_ ·

      In reply to Printer Problem WithX.P.

      This question was closed by the author

Viewing 3 reply threads