General discussion

Locked

Printing the tranparency problem in Powe

By logic_25m ·
I have a transparency of 8x11" and Epson Stylus 600 inkjet printer. I want to print a slid but Power Point always prints it in two transparencies while I want my output on single. I also changed the papersize but the length of output is not being changed.

This conversation is currently closed to new comments.

2 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Printing the tranparency problem in Powe

by waifoon In reply to Printing the tranparency ...

When you said you have changed the paper size, did you changed it at the printer's properties, or under Powerpoint under "File" -> "Page Setup" ? Perhaps you should try changing at both sides.

Collapse -

Printing the tranparency problem in Powe

by logic_25m In reply to Printing the tranparency ...

Thanx dear you solved my problem. Thanx a lot and 10 points is your right.

Back to Software Forum
2 total posts (Page 1 of 1)  

Related Discussions

Related Forums