Windows Forum

Ask something
Discussion Locked

Problem with device driver

0 helpful
1 reply

by ganeshgkrishnan

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My pc configuration is pentium II processor with 4GB hard disk drive my problem is when i switch on my computer after the booting sequence i am getting an error message stating that a device file named nwnblink.vxd to run windows or windows application has been deleted. if you have deleted this on purpose try uninstalling the application
System.ini file refer to this device file which is not current present.

i searched the system.ini file to find the nwnblink.vxd i am not able to trace it

pl. help me in sorting out this problem

with regards
v. ganesh

1 reply

by mdelyea

A network protocol was not fully installed or was incorrectly installed. Remove all network adaptors and protocols from the network section of control panel. You will then have to reinstall the adaptors and protocols. If you are not on a network you will only need dial-up adaptor and tcp/ip. If you are using high-speed internet or are connecting to a network, you will also need the correct driver for your network card and maybe another protocol (netbeui or ipx/spx).

This discussion is closed to new replies.