I recently built a new unit with a FC azIIe motherboard & a 1 Ghz AMD processor with WIN 98 SE. My problem is the zoom 2925M PCI 56K modem. I have installed the 4in1 patches from VIA. I have installed the newest zoom modem install files. The modem is on its own com port & IRQ with no conflicts at all. The modem returns normal data when communicating. The phone line is installed in the line port! I attempt to dial. There is no dialtone. I force it to dial but phone line says if you are attempting to dial, please try again. I put the modem back into the older pII 350 with same lines. The modem works fine. ISP says I am configured ok. I have a TCP/Ip with the dialer. I think either VIA or Zoom drivers are at fault? Does anybody have this problem? Any suggestions? Anybody with this combination without problems?
Thanks in advance
Richard Bolha
Dragon@one.net
