General discussion

Locked

PS2 Mouse Port - pinouts required

By bobross ·
I have an AT motherboard that has a 5 pin connector for a PS2 mouse port. I have obtained a suitable PS2 connector/cable assembly, however the 5 pin header wiring doesn't match the pinnouts on the motherboard so I need to rewire the header. Does anybody out there have a pinnout diagram for a PS2 port???

Thanks.

Bob (bobross@dove.net.au)

This conversation is currently closed to new comments.

6 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

PS2 Mouse Port - pinouts required

by WanabeDrSean In reply to PS2 Mouse Port - pinouts ...

i will happy to give it to you in the morning when I wake up 9:00 cdt

Collapse -

PS2 Mouse Port - pinouts required

by WanabeDrSean In reply to PS2 Mouse Port - pinouts ...

1 data
2 reserved
3 GND
4 +5V
5 clock
6 reserved
Also used for PS2 mice, they are interchangable except for the data format below is a pin number assighnment for the port the pipe symbol or vertical dash corosponds to the key part of the connector as your looking into a male connector

5 | 6
3 4
1 2

Collapse -

PS2 Mouse Port - pinouts required

by bobross In reply to PS2 Mouse Port - pinouts ...

Poster rated this answer

Collapse -

PS2 Mouse Port - pinouts required

by Some Guy in Seattle In reply to PS2 Mouse Port - pinouts ...

If you use www.google.com and search for "ps2 mouse pinout" there's a number of sites there that can give you the info. I chose this one as it had the physical position of the pins in the connector as well as what is on each pin (no spaces in URL):

http://www.hut.fi/~then/mytexts/mouse.html

Hope that helps -

Collapse -

PS2 Mouse Port - pinouts required

by bobross In reply to PS2 Mouse Port - pinouts ...

Poster rated this answer

Collapse -

PS2 Mouse Port - pinouts required

by bobross In reply to PS2 Mouse Port - pinouts ...

This question was closed by the author

Back to Hardware Forum
6 total posts (Page 1 of 1)  

Related Discussions

Related Forums