Question Locked

Quantum Fireball lct15 30gb jumper settings

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have this 30gb quantum drive and I can't get my computer to recognize it. I recently installed another hard disk to the motherboard with a spare IDE ribbon I had laying around. I decided I would connect this third drive as the slave to that one. The computer doesn't seem to know it's there. I think the problem may be with the jumper settings. On the disk, it lists 3 settings; one for master, one for slave, and one for cable select. The other drive is set to cable select so I set this oen the same way. It only came with one jumper and the picture shows only one jumper. However, on the Seagate website (Seagate bought maxtor) it shows that the drive should have 2 jumpers. What is going on here?

8 replies

by bax2x

I currently have the jumper set to cable select according to this web page's directions. It's the same directions that are listed on the top of the drive.

by willcomp

CLJ is Capacity Limiting Jumper --- limits capacity to 32GB on 40GB and larger drives for compatibilty with older BIOSes.

Only a single jumper is needed for your drive. Horizontal jumpers are in storage position (not connected).

Jumper drives as Master and Slave rather than Cable Select (CS) and see if that helps.

To ensure cable compatibilty when using CS, you will need an 80 wire, 40 pin IDE cable.

by bax2x

Yeah, I forgot to plug in the power. But, in the process I did change the drive to slave and the other one to master. Thanks for the help.

by willcomp

Yes, it does help to have molex connector plugged in.

This discussion is closed to new replies.