Question Locked

RAID 5 ON Gigabyte motherboard...!

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Can anyone pls tell me the whole process of configuring RAID5 (Hardware Based) on the Gigabyte MB EX-38-DS4 Motherboard with 3 HDDs 250 G.B. SATA-3.
Do I need to add any RAID Controller Card or without it I can configure RAID 5 on this board.
Thanks in Advance.

2 replies

by thechas

Chapter 5 of the EX-38 user manual looks like it covers RAID setup pretty well.

You DO need to setup the BIOS for RAID operation, and configure your RAID array prior to formatting the drives or installing Windows.

One key note in the RAID instructions is that only those levels of RAID supported for the number of drives installed are available. In section 1-9, they do state that 3 drives is the minimum number for a RAID 5 configuration. Make sure the drives are plugged into connectors 110 - 112.

Once you have the RAID array configured, you then MUST use the RAID driver disk when installing your OS.

There are instructions for creating the driver disk.

Chas

This discussion is closed to new replies.