Discussion Locked

Ras in Win 2k

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have upgraded my NT 4.0 server to Win 2k ( a clean install) On NT I had a Digi multiport controler with a Us Robotics Modem for our sales staff to dial in. In Win 2k I cannot get my modem to answer. I have enable Ras and routing. I have set thepolicy to allow Remote access. I can hear to modem kick in on the server but on the laptop I am dialing in with it come back with no answer. What could the problem be. There are no device conflicts

8 replies

by cg it

In control panel, admin tools, open up RRAS, in the left pane, expand your server name choose ports. you should see your modem in the right pane and it should indicate it's listening. If you right click on your modem in the right pane, you can refresh to make sure it's listening.

Also, check to make sure your modem is operating properly. In the control panel, open modems, do a diagnostic test on the modem and make sure the command string is sent properly through the loop back address.

If your modem is listed in RRAS as listening, and a diagnostic test shows the modem functional, it could be that your firewall or packet filter programs are not allowing a dial in connection.

by cg it

I had the same problem once and found that the modem was bad. It was working properly and then just up and quit. The modem had been using comm port 3 and even changing to a different comm port didn't fix the problem. I ended up changing out the modem and Volia! no problems! I never did check the old modem in another computer to see if it was actually bad.

by joseph moore

Did you check Device Manager to make sure your Digi multiport controller is listed?
Did you check Phone & Modems to make sure all of your USR modems are there?
Did you configure RRAS? Did you assign an IP pool? Did you run the RRAS wizard and tellit that the RRAS box will service dial-in clients??

There are a lot of questions that need to be answered. RRAS is really easy for dial-up clients, if you can answer the questions. I run RRAS myself with a multiport board (8 modems for my RRAS clients is sweet!!!)

hope this helps

by shmaltz

I have had problems like this before, what helped for me was to disable "Negotiate multi-link for single link connections" on the client side. This setting is accessed on the network tab of the Dial Up setting property under settings.

This discussion is closed to new replies.