TechRepublic|Forums|Windows

Windows

General discussion

  • Creator
    Topic
  • September 15, 2003 at 7:21 pm #2297985

    Re-enable on-board video

    Locked

    by rydctlc · about 19 years, 8 months ago

    After disabling on-board video (without installing new video card) How do you re-enable the on-board video. During boot-up the screen flashes the on-board video type then goes blank. Running XP home. Any suggestions would be appreciated.

    Topic is locked This conversation is currently closed to new comments.
  • Creator
    Topic

All Comments

  • Author
    Replies
    • September 15, 2003 at 8:36 pm #2741831

      Reply To: Re-enable on-board video

      by fred07 · about 19 years, 8 months ago

      In reply to Re-enable on-board video

      hi

      You need to open the unit and reset the cmos jumper to clear for 3 seconds.

      fred

    • September 15, 2003 at 9:14 pm #2741826

      Reply To: Re-enable on-board video

      by dmiles · about 19 years, 8 months ago

      In reply to Re-enable on-board video

      Boot Computer,when Startup screen appears,press the designated key to enter setup(look in the bottom left corner for reference),once you enter setup configuration locate onboard graphics,highlight then right-click you should se the choice to enable.

    • September 24, 2003 at 9:38 am #2743888

      Reply To: Re-enable on-board video

      by william jay · about 19 years, 8 months ago

      In reply to Re-enable on-board video

      Howdy,

      It depends on how and where the video chipset was disabled. If it was done by jumper and/or BIOS, move the jumper and enable in BIOS. If it was done in XP only, tap the F8 key on system startup and when the boot menu appears, choose Start in Safe Mode. . .

    • February 8, 2004 at 8:56 pm #2697739

      Reply To: Re-enable on-board video

      by rydctlc · about 19 years, 3 months ago

      In reply to Re-enable on-board video

      This question was closed by the author

  • Author
    Replies
Viewing 3 reply threads