Question Locked

Reconnecting all power cables on mother board for EMACHINE

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

So a few months ago my computer went dead. I opened it up and decided it wasn't something I had time for. so i took it to a place and had them look at it. they said it was the power supply. and wanted a ridiculous amount of money to fix it so I just got another machine.
Well now I bought the power supply and reconnected everything but I disconnected three small cables from the board that I think work the power button on the front of the computer. they say hdd led, pwr led, pwr s/w. So I need help in reconnecting those I know where they go but I'm not sure if they have a certain order... and I have tried a combination of things but can't get it to power up.

HELP

3 replies

by willcomp

Connect only the power switch lead and see if PC will power on. If not, keep reading.

eMachines PCs with Bestec power supplies (PSUs) have a common failure mode where capacitor in PSU fails and takes out voltage regulating module on motherboard. Replacing both PSU and motherboard is required.

by tintoman

It is always advisable to change motherboard and PSU together, however assuming your motherboard is ok you will need to download a manual for your motherboard to find out the correct pin configuration for your front panel connectors, if you have already connected them in the wrong order there is a chance that you have damaged the motherboard anyway. by the way there is also a possibility that the PSU failure caused other damage to HDD, optical drives, RAM amd processor, sorry for the doomsday scenario but I have seen this many many times.

This discussion is closed to new replies.