General discussion

Locked

regarding bandwidth

By ven_257 ·
can we manipulate the bandwidth in the cisco router which is coming into it,when it is diverted to other network?

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by BFilmFan In reply to regarding bandwidth

You mean inside the router itself?

Collapse -

by mshavrov In reply to regarding bandwidth

The short answer is YES. But you have to be more specific. First, answer to yourself, what do you want?

* Limit the bandwidth for particular applications?
* Limit bandwidth for specific users?
* Get some traffic higher priority than other traffic?
* Is it inbound traffic or outbound?
* Should it be just a local limitation or it should be through your network?
* If it's Internet traffic, does your provider supports this limitations/prioritization?
* What amount of traffic you are talking about?
* What if traffic comes at higher rate than you expect, is it OK to drop the exceeding traffic?
... etc.

For basic information, look for "QoS" term - traffic management is part of the "Quality of Service" suite. Look at the Cisco website for "QoS" to get all information required. Or hire consultant. :-)

Good luck,

Michael Shavrov
CCNP, CCDP, CCSP, MCSE W2K, Security+, etc.
http://www.ciscoheadsetadapter.com

Collapse -

Limit Bandwidth on CISCO router

by jwxt In reply to

Vaguely. I want to limit bandwidth coming in and out from the switch to my router. (on the Router) what must be done. I have been reading up on MTU and MSS, but unsure quite how to make the router config changes.

Back to Networks Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums