Question Locked

Reinstalling Windows XP Pro but Set up not allowed access to disk

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Due to my machine failing to boot up any longer(it would hang up at the screen where you could select to boot up into safe mode or run Windows normally), I reformatted my hard drive and reinstalled Windows XP. Everything seemed to go fine but now when it boots up it goes to a black screen. So I tried to reinstall Windows XP but I get the error that Set Up cannot access the disk. I tried to go through Recovery Console and format Drive C but the only drive that shows when I put in the map commany is Drive D. Any suggestions?

4 replies

by cmiller5400

Does the drive show up in the BIOS? Have you run the HDD manufacturer's diagnostics tool to see if the drive is bad?

by jdclyde

Most likely it was locking up because of a bad HD.

by tintoman

Actually the answer to this depends on how you went about installing windows, if for example you deleted the orignal partition during setup and created and formatted a new one, then I agree with these guys and suspect a faulty drive, if you did not do that then you will now have 2 installations of windows and thus a boot issue since one of them is known to be corrupt

This discussion is closed to new replies.