remote installation boot disk for RIS

start,run, ant type in command rbfg.exe, this will initiate to make ris bootdisk.

good luck.

i take it you already have installed RIS component.

sorry about last post this is the correct command,start,run, c:\WINNT\system32\reminst\RBFG

rem your NIC must be PCI for this service.

To create a remote boot disk

Click Start, and then click Run.
Type the UNC path of the Rbfg.exe utility, and then click OK. Example:
\\servername\REMINST\Admin\I386\RBFG.exe
Insert a formatted disk into the disk drive.
Click the Destination drive option, and then click Create Disk.
Click Close when the disk is ready, and then remove the disk from the disk drive.
Note

You can use the boot disk only with computers that contain supported PCI-based network adapters. To view the list of supported network adapters, start the Rbfg.exe utility and then click Adapter List.
taken from microsoft files
hope it helps