replaced inspiron 4000 motherboard, and there are issues

By irishscott65 ·
the new board is for the inspiron 4000 and latitiude c600. it boots as a c600. how do i correct this? the other issue is that it will boot from battery, but with power cord it cuts off after 2 or 3 seconds. it also just decides to cut out at different points while running. actually i am not sure if there is an issue whether it is a 4000, or c600 as long as it runs the same. it reads the cpu ok so i don't know if it matters.

This conversation is currently closed to new comments.

Thread display: Collapse - | Expand +

All Answers

Collapse -

Request for Clarification

by hezkiah In reply to Clarifications

did you up grade the bios when you installed your mother board

Collapse -

contact HP....

by ---TK--- In reply to replaced inspiron 4000 mo ...

or who ever replaced the MB... and have them replace it with the correct one. Its not uncommon to order a MB from HP and its DOA or the wrong part...

Collapse -

Check power connector on MB

by ken In reply to replaced inspiron 4000 mo ...

I have a HP Compaq that would do this. I resoldered the power connector on the mother board and that fixed it.

Related Discussions

Related Forums