Networks

General discussion

Creator

Topic
November 17, 2003 at 11:40 am #2297343

Request time out

Locked

by nelk_w · about 20 years, 5 months ago

Recently I set up a small office network which is having 10 computers with a “SuperCom EP-824DX” 24 ports swicth.I tested the network wires with a Lan Cabel Tester.All cabels ok.But the problem is when I ping after 2 or 3 replies there were a request time outs, then once a again replies. What could be the problem

thnx

This conversation is currently closed to new comments.
Creator

Topic

All Comments

Author

Replies
- November 17, 2003 at 4:22 pm #2676830
  
  Reply To: Request time out
  
  by albert2001_it · about 20 years, 5 months ago
  
  In reply to Request time out
  
  Something similar happened to me, you should shut all the computers down, then reset the switch and turn the computers on one by one. Then ping the computers as you are turning them on. If that does not fix the problem you should see if your switch is working properly.
  Hope this helps
- November 18, 2003 at 9:42 am #2676621
  
  Reply To: Request time out
  
  by gigelul · about 20 years, 5 months ago
  
  In reply to Request time out
  
  Other problem can be the lenght of cables (max. 100m) or a bad NIC card. I had a 3Com NIC card which didn’t work with a 65m cable and an old ISA card worked.
- November 25, 2003 at 5:40 am #2675157
  
  Reply To: Request time out
  
  by pesk, mbcs, mcse, mcitp, sts · about 20 years, 4 months ago
  
  In reply to Request time out
  
  Check to make sure that ALL the NICs are set to same speed 10Mb, 100Mb or to AUTO)
Author

Replies

Viewing 2 reply threads

Start a Discussion

Start New Discussion