Discussion Locked

Restore from backup set

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Windows 2000 backup on 32-disks (zips). Disk 1 thru 7 loads fine, keep asking for disk 8 even when its in the drive. Can't go any further. What can I do to get this backup back onto the system. Very very very urgent!

3 replies

by timwalsh

Most likely the data on the disk is corrupt. Can you see any contents of the disk in Windows Explorer? If so, can you access the properties of the contents? If not, the data is probably gone.

You might take a look at MS KnowledgeBase article 244805 - How to Restore Data from a Backup Set that Contains a Missing or Corrupted Tape

Although the article refers to tapes, the information should hold true for any valid backup media.

I promise not to make the obvious observation that for the money you spent on zip disks, you probably could have found a tape backup of sufficient capacity to fit your backup on one tape.

by hgh972

Already checked knowledge base for missing or corrupted tape, either i didn't understand or didn't work. I didn't know the backup was going to be on zips, but responsible for getting the backup back on to the system. I have run scan disk, moved the file to hard drive and run defrag. the file is there. 2-5-03Backup.bkf. Cannot see the files individually. The disk is okay. the file is okay. Properties show the file is out of sink with others. example of disk 7 "created Feb 5 2:26" disk 8: "created Feb 7 8:43" how can i change the properties to put it in sequence with others?

This discussion is closed to new replies.