Discussion Locked

Restrict a IP address to a MAC-ID

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi

I have a flat network(VLAN's not implemented) of 400 nodes with 3 subnets, I have setup a WIN2K DHCP server with client reservation for all PC's i.e each PC's NIC MAC-ID is associated with a fixed IP address. The network is fine and the DHCP server also works fine with the superscope option in place

I need to restrict a PC with only that IP address on the network i.e in the event if any user types in a IP address of another PC which is currently offline, that PC with a forged IP should not be given access in the network,

In summary what I want to achieve is that when a IP packet comes out it should be from that matching MAC-ID of that NIC alone which I have set in the DHCP server, i.e even if a user types in a IP address in his/her network settings it should not be allowed to access the network

I understand that I have no group policy or no central login process is taking place, I am just abt restructuring the Network and I cannot set group policy as of now

Is there any other way to solve my problem, all help is appreciated

Warm Regards

Aaron Solomon

4 replies

by itnetman

Is there any reason why you do use a static IP address instead of using DHCP? This is what we would do. Hope this helps.

by arunsolomon

As a measure of security and for audit logging based on IP address, I have implemented the DHCP server this way.

by mike jones

The DHCP server cannot stop traffic, it only allocates addresses.

There is nothing to stop a user entering an IP address and hoping for the best.

You will have to use some other system to block the traffic if the mac address and the ip addressdo not match to what you have listed in a table.

There maybe some third party firewall software which you could install on the same server as the dhcp server, but I can't imagine it being cheap. I would imagine there would be some way of exporting the ip/mac address information from the dhcp table which you could possibly programatically import into the firewall software, but again not easy.

You might have to wait until the restructuring is finished.

We did have a bit of software years ago, which mapped mac-address to switch ports to stop people from plugging their pc's in just anywhere, again not cheap.

Telewest is my service providor and they restrict the dishing out of IP address at the cable modem, so if the mac address ofthe cable modem is not registered then you cannot get to the dhcp server, but even with this you can then swap the ip address if you know the range once your mac address has been registered. However, telewest scan the ports and will soon shut you down if they get duplicate ip address error messages.

This discussion is closed to new replies.