Discussion Locked

sdram-issues

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have several motherboards from socket 7+ to pentiumII/III(older ones). i tried out pc100 and pc133-memories. i do not want to go into much details at the moment.buffered, unregistered, high density cl 2/3 etc. this could be discussed in a separatequestion when i have more facts. on the oldest MMX-mb(No1) all memories were accepted and one single 256mb-133 counts up, pc100 too of course. 1x256(133)+ 1x64(100) are counting up but windows me only shows 256. can i take out the 64mb? because theywould not help. i use one 256/133 because they are cheap(instead of 2x128/100). ok price difference is small. are there 256/100 around.
board 2(mmx) does cut 50% of the pc133. i had to buy pc100. board 3(PII) has fsb 100, is fsb 100 and pc100 related and the cause it does not count up or is it more difficult. on one PIII-board is said 6x133(800mb-processor will be cut to 6x100(600) due to the fact its fsb 100 and if i use pc100. there is a possibility to use 3x256 registered, (ecc evtl) but they are expensive.is are there registered with and without ecc? if they are pc133 the processor could anyway be cut as mentioned above. or do i err. anyway: its not worth investing into old pIII plus sdram because new ddr-ram pentium 4 are very cheap.for 550 usd i get a whole machine here in switzerland.

6 replies

by cg it

Ya know, the best thing you can do when faced with questions regarding which memory is compatible with what board is to get the manual for each board. It would save you a lot of headaches and time in trying to decide what is what and what to do. www.motherboards.org boasts the largest selection of motherboard manuals on the web. Try there. Also, you questions seem to center around using PC 100 and PC 133 dimms and the compatibility of those dimms are on the old motherboards you have. To answera question about FSB core clock speed of the processor in relation to memory core clock speed and whether or not what type of memory you put in [PC100 vs PC133] effects processor speed, the answer in no. Finally, Yes, investing in old Pentium III systems is not worth it. Go fishing, take em with you, ....have a few beers, come back with fish, a smile and no computers.

by cg it

note: when I say that the memory has no effect on processor speed, that means the core clock speed the processor runs at. NOT overall system performance. Yes, what memory one uses and what processor one uses does effect overall system performance. But putting in PC 100 Sdrams in a system vs. PC 133 Sdrams doesn't change or effect what core clock speed the processor runs at.

by stuart_at_oz

You may findproblems using new RAM on old motherboards - new RAM is often double sided, but older boards can only recognise single sided - so you either olnly get 128 of RAM from your 256 DIMM, or it just wont recognise it. I had this happen to me on two PC's, the choices are to buy more expensive single sided RAM, or update the board.

Stuart

This discussion is closed to new replies.