Hello,
I have a question about how to setup NAT using Cisco Routers. Here is the situation. I have multiple Dealer Sites. Each site has multiple users. Each of there networks have their own set of IP address’s. They could be the same, I don’t know. We want each dealer to be able to come into our DMZ through a firewall. We are going to be using Cisco Routers and we are in the Process of purchasing a couple of 1720 to do some low end testing. My question is, How would we go about doing this. Would we need to Translate on the dealers end and then again on our end? Does it need to be a dynamic change, or do we need to set up a Static Translation? Is there a diagram out there that shows how this would work, with multiple remotes coming into one host using NAT??
I know this is a lot of questions, but I hope this makes sense.
Thank you for your time
Kevin
