Discussion Locked

Show ports

0 helpful

3 replies

by hanriky May 22, 2002 last reply Jun 24, 2002

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

How to show all ports (used or unused open ports) in a NT4 Dos Prompt? And how to remove the port with a command? Or utility?

I am using LanGuard Network Scanner, but it crashes a server.

3 replies

NETSTAT -a will list all listening and active ports.

NETSTAT -n will only list the active ports.

Poster rated this answer

This question was closed by the author

This discussion is closed to new replies.