Discussion Locked

Size allocation while loading NT4

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a 40 GB HDD. I need to split this into 10 GB and 30 GB partion. When I specify 10 GB during installation the NT OS displays that this partion is too big and the max permissible is just 2087 MB.
How do I go about alloting 10 GB FAT and the remaining NTFS?

8 replies

by beermonster

Hi,
I was discussing this very thing the other day with a colleague. NT only allows the initial partition size to be around 2gb, and does not allow you to extend it UNLESS you are doing an unattended install, in which case you can use the extendoem partition switch (note that bthe maximum size for the boot partition in NT is 8GB). the discussion centred around why on earth Microsoft would offer this option during an unattended install, but not allow you to do it during an attended install. The result of the conversation was along the lines of 'hey, that's Microsoft for you'. The problem centres around the fact that the text based portion of setup formats with FAT (and converts to ntfs later)- NT can't read fat32, so the only other format available is fat - which has the 2gb upper limit (although you can get this up to 4gb if you format using 64kb clusters - create and format the partition using a bootdisk rather than the NT disk and specify 64kb clusters during the format). The only way I know of to achieve what you are after (other than using third party tools like partition magic) is to take your disk and put it in another NT machine, and create then format the partitions to whatever size you like. Then return the disk to your machine and install NT. You might also try installing NT onto a 2gb partition, create a 8gb partition and format it, then install nt again on to the 8gb partition and delete the 2gb partition during the install. Hope this helps...

by steve penn

The problem you have here was resolved in service pack 4 for NT. It's the atapi.sys file which can only see 2gb. With the sp4 version it can see 8gb.

what you do is basically press f6 during install to install a 3rd party driver and install your new atapi.sys here. you will then be abale to create up to 8gb.

http://support.microsoft.com/default.aspx?scid=kb%3Ben-us%3B197667

It's all explained in the above link. To go over 8gb - i'd use PQ Partition Magic or somelthing similar.

Steve.

by steve penn

sorry - im talking crap. dont press f6 for a 3rd party driver but press 's' for a mass storge device when asked.

by curlergirl

What the other responses have said is correct. Just to clarify - there is NO WAY you can create a 10GB FAT partition. If you want to create a 10GB NTFS partition for installation of your OS, then you can do what the others have said, such as create a 4GB partition on the initial install and then use Partition Magic to extend the partition to your desired size. If you insist on using FAT for your system partition, then 4GB is your maximum, and you have to do this by pre-partitioning and pre-formatting the partition, as the NT install will not allow this. Hope this helps!

This discussion is closed to new replies.