General discussion

Locked

stop error

By jamesjohnson79918 ·
I,m rebuilding my computer from a old system. I keep on getting an stop error. Please, check hard-drive or virus protection. After cheching hard-drive cable there is no power and the power switch isn't working.

This conversation is currently closed to new comments.

1 total post (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

stop error

by Ann777 In reply to stop error

Replace the power supply.

Depending on the form factor of your system (AT or ATX), you should have one or two leads from the power supply into your systemboard. Then verify that one of the power supply connectors connect to your hdd. Make sure the flat cable from the system board connects into the hdd as well. Then power up the system. Do not touch anything inside while the system is powered on.

If the fan on the power supply turns and you still get the same error, then look at trying another hdd, cable, etc.

Back to Hardware Forum
1 total post (Page 1 of 1)  

Related Discussions

Related Forums