General discussion

Locked

Stop errors

By rpalfery ·
Win2000 unexpectedly shuts down. After re-booting it blue screens with message: beginning dump physical memory. How do i determine what is causing this?
thanks for yur time

This conversation is currently closed to new comments.

8 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by gralfus In reply to Stop errors

Which stop error is it? There can be many causes. Is there any common factor (such as printing) right before this happens?

Collapse -

by rpalfery In reply to Stop errors

The stop codes are 0x000000D1, 0x342B46,DRIVER_IRQL_NOT_LESS_OR_EQUAL_TO. There was more ,but all i could get from client. No common factors that i know.after re-boot (about two minutes) it blue screens. My guess is USB driver related? Hope this helps-thanks

Collapse -

by shripalkkad In reply to Stop errors

The bios battery must be week. this can give the error your getting if its starting to go dead as it saves the bios settings incompletely.

but do look in device manager if you can get to windows. it can also be caused by two conflicting peaces of hardware trying to use the same irq settings or chanels at the same time.

Collapse -

by Power Natto In reply to Stop errors

If the system is unstable, boot into safe-mode and have a look at Event Viewer or Performance logs in Administrative Tools for further clues.

Collapse -

by rpalfery In reply to

Poster rated this answer.

Collapse -

by dmiles In reply to Stop errors

You may receive the following error message on a blue screen:

STOP 0x000000D1 DRIVER_IRQL_NOT_LESS_OR_EQUAL (0x0,0x0,0x0,0x0)
Parameters
1 - memory that is referenced
2 - IRQL
3 - value 0 = read operation, 1 = write operation
4 - address that referenced memory

CAUSE

This issue can occur when the Driver Verifier feature is enabled and a driver has used an improper address. Note that the driver that is causing this issue may be listed in the error message.

RESOLUTION

To resolve this issue:
Disable all third-party filter drivers, such as backup programs, virus scanning programs, and disk utilities.

Make sure that you are using hardware that appears on the Windows Hardware Compatibility List (HCL). To view the latest Windows HCL, visit the following Microsoft Web site:
http://www.microsoft.com/hwdq/hcl/

Collapse -

by rpalfery In reply to

Poster rated this answer.

Collapse -

by rpalfery In reply to Stop errors

This question was closed by the author

Back to Windows Forum
8 total posts (Page 1 of 1)  

Related Discussions

Related Forums