Discussion Locked

System lockup-Windows 2K during startup

0 helpful
22 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Gateway E-4200 that locks up during startup. Windows 2K has aready been reinstalled and format set to NTFS. All hardware has checked okay and replacecement of the video driver does not help. Will only lockup with cold boot. Will not lockup with warm boot. Will boot okay after rebooted, but not after more than 30 minutes.
Locks up after the startup screen with the progress bar and before Ctrl-Alt-Delete prompt.

22 replies

by wcp

This is most likely a RAM issue. Because the problem appears only on cold boot, you may have only one or two tries (steps) a day. So be patient.

Do the following.

1). Reseat RAM(s) firmly.

2). If you have only one RAM, replace it with a known good RAM.

3). If you have more than one RAM, you need to isolate which one (or more) is bad. The easiest procedure is to take all of them out and put one at a time until the error is gone.

by wcp

The last line should have said "until the problem reappears" not "until the error is gone".

by joseph moore

When you boot into Safe Mode, does it stay up ok, or does it lock up there also? If it is ok in Safe Mode, then you just have a Service or program that starts on boot that is not behaving properly.
So, what are the results of booting (cold and warmboot) into Safe Mode?

by raymond nelson

System unit will not boot in safe mode on a cold boot. There should be no problem booting to safe mode on a warm boot, but not after more than 30 minutes. Of course this is true of a normal boot so I see no advantage of booting to safe mode on a warm boot. Your thoughts Joseph Moore? Thanks!

by bobho

If you can get it to boot up in safe mode then I agree with the above. Even if you cannot, try doing a logged boot to give you a starting point as to where the system is hanging.

DrBob:>)

by raymond nelson

System unit will not boot in safe mode on a cold boot. There should be no problem booting to safe mode on a warm boot, but not after more than 30 minutes. Of course this is true of a normal boot so I see no advantage of booting to safe mode on a warm boot. How can I initiate a logged boot for a cold boot noteing the information above so as "to give a starting point as to where the system is hanging".
Your thoughts Dr. Bob? Thanks!

by raymond nelson

I will try a logged boot if possible so as to find "a starting point as to where the system is hanging". Thanks!

by wcp

I truly believe this is a hardware problem not Windows.
Have you tried step 2 or 3?
No error by a diagnostic test on RAM(s) or being able to install Windows without problem (Well, actually there is) do not mean your RAM(s) are O.K.

by raymond nelson

System unit will not boot in safe mode on a cold boot. There should be no problem booting to safe mode on a warm boot, but not after more than 30 minutes. Of course this is true of a normal boot so I see no advantage of booting to safe mode on a warm boot. How can I initiate a logged boot for a cold boot noteing the information above so as "to give a starting point as to where the system is hanging".
Your thoughts Dr. Bob? Thanks!

by abelnguyen

Are you able to login before it lock up?
Do you notice when did you system start behave like that? At that time, did you install any new hardware or change any BIOS setting?

by raymond nelson

The system unit locks up before the prompt for Ctrl-Alt-Delete. No new hardware or change in BIOS setting. System unit was okay before Christmas break, but started the lockups after the first week in January.

by bobho

Have you tried resetting your bios? Go into the bios and reset to "Default", "Conservative" or "Non-Aggressive" if one of those options are there. Try disabling "pnp OS".

Can you cold boot to a DOS startup disk (just trying to see if it's w2k or not)?

DrBob:>)

by raymond nelson

Reset BIOS to Extended System Configuration Data(ESCD). Did not help with the problem. Have yet to try "cold boot to a DOS startup disk" Thanks!

This discussion is closed to new replies.