10 replies
by t.wilford Accepted solution
by retro77 Accepted solution
by langlier Accepted solution
use it wisely.
Also what format is the 2nd hard drive with the data in?
by t.wilford Accepted solution
by t.wilford Accepted solution
by langlier Accepted solution
the next step would be to use a diagnostic tool to verify the integrity of the drive (is the drive physically busted). Theres a few other tricks like clearing out the master boot record and using programs like Partition Magic as well... but things may not be recoverable and you may end up needing to reformat. Other things to check if the diagnostic comes back clear:
1. Does the disk work in another CPU?
2. Does the disk work in a USB carrier?
3. Are the jumpers on the disk configured correctly? Can you change them to an alternate configuration?
by ic-it Accepted solution
by ozi eagle Accepted solution
Hi,
How did you write the data to the disk?
Assuming that it was installe din another computer, try putting it back and see if you can still access it.
If it still works network the two computers with a crossover cable and copy the data to the new computer. Then place this hard drive into the new computer, format etc and copy the data back onto it.
Herb
by sdfischer2004 Accepted solution
I had the same situation when I rebuilt my XP install today. I run my OS off the primary Hard drive and use a 320GB slave drive for my data (NTFS on both). After the install drive managment reported the data drive as unformatted and unusable. I booted into a linux CD and was able to access my information.
I ended up looking at the MBR of the second disk with the linux 'fdisk' utility, it reported my Data disk type as 'ez-disk' when it should have been NTFS -- somehow when XP was installed on the primary disk it changed the MBR of the secondary also. Very not cool. I could not find any utility in windows to change this back, so I used fdisk to change the mbr to what it was supposed to be.
I rebooted into windows and XP recognized the drive without any problems.
I guess linux does not look at the MBR when trying to mount a partition or a drive. Windows is dependant on the MBR to be accurate in order to access the drive. My problem was retarded because there was no simple way to solve it, I am assuming a lot of people would have given up - I worked a lot with fdisk before and I had the resources to test run my fix action - my data was protected. Most people are not in that situation.
by imran_dop Accepted solution
1-Check the jumper setings.
2-Try openin it in safe mode.
3-Or else format ur harddrive n recover ur data back.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending