Discussion Locked

toshiba tecra 8100 unable to boot

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I had a power pin fault (had loose connection with board circuit) and managed to fixed by removing the board and rejoined with soldering iron. then it works ok but the lcd display became blinking and then turned into negative film like colour(like a film negative shading-no original colour). then restarted, the lcd panel changes with in 5-10 minutes of working. then removed the cover and screwed all threads well and removed and connected the lcd cable to board. But now no booting but the power lights (3) comes as usual, when push the power button, the sounds of starting comes but the hard disk or processor light didn't turn on and processor fan is not working. But the battery getting charge and some fan sound is hearing, beep sound comes when press lcd closing button in the front and dvd drive opens. Only one time when i unplugged the power cable and started, the screen with toshiba appeared and windows started and got struck. I changed another hard disk but same appears.
Specifications:

OS : Windows xp
Speed: PIII
RAM : 256

please help to solve the problems.

thanks
ratha

2 replies

by older mycroft

There is the possibility that your soldering may have damaged the motherboard in a way you cannot visually detect.

You may also have ended up with a repaired connection that now has a dry joint, causing intermittent current flow.

I'd have another look at the connections for ALL ribbon cables and wired/plugged connectors.

What do you mean by [i]"..then removed the cover and screwed all threads well.."[/i] as laptops don't take kindly to aggressive or rough treatment. ;)

by bkratha

thank you for supporting, i think it is 30 wats. i have tried to unscrewed, and screwed smoothly as you mentioned-thanks for your guidance,removed RAM and cleaned, replaced, now the machine working but the monitor screen shows blinking and turns to negative like some times then automatically comes to normal, it happens when lot of processing is loaded. If the table fan is on, the blinking is less.

This discussion is closed to new replies.