General discussion

Locked

Trouble updating firmware for Cisco 1900

By meanes ·
When I boot my 1900 series catalyst Cisco switch, I get and "invalid" firmware message, and am instructed to update firmware. I've gone to cisco website and downloaded firmware software. I then attempt to transfer that file using Xmodem protocol to switch, but when I do I get a message that the remote host rejected the transfer. I've triple checked the settings, using 9600, 8 bits no parity and no flow control. Any suggestions?????????

This conversation is currently closed to new comments.

0 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Back to Desktop Forum
0 total posts (Page 1 of 1)  

Related Discussions

Related Forums