Question Locked

Upgrade a motherboard to a new case

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Upgrade a motherboard to a new case and the case dosen't have the right front pannel conector it in one conector not many.

8 replies

by the scummy one

researched the case before purchase, and compared it to your MB.

what connectors are you talking about??
If it is a front panel port setup, then you may need to alter the case to add it. However, you shoul dbe able to function without it.

by Former member

Please give use a clue.
:) :)

Please post back if you have any more problems or questions.

by fincke

It a VPR Matrix ft4100 case from any old computer. The motherboard is a Asus M2a-VM DVI.
The on and off switch conector or not the same as most other case. where you have 3 or four conector for you pwr reset or speaker instead of being all separate the are made into one signle conector.

by Former member

All you do is put this plug (of which might be blue in colour) into the usb (colour blue) port/socket on your motherboard, if you have a card reader then this will take another port/socket on its own. Please read both manuals of both motherboards and find the right plugs/sockets and place them correctly in their corresponding sockets.

Please post back if you have any more problems or questions.

by jdclyde

All you NEED is the power connected.

The rest are just bonus.

If you can post what the mother board is and maybe the case, we could give you a more detailed answer.

Bottom line, extra doesn't matter and nothing to worry about.

by fincke

The motherboard has a 20-8 system panel connector it dose say you don't have to use all the connector however to connector the IDE led or the Pled you have to jump to the other side of the connector in order to get the mother board to stard up and work properly I think I'll just buy a new case.

This discussion is closed to new replies.