General discussion

Locked

USB port to label printer

By BarryVG ·
Have a DYMO label printer attached to USB001 on computer. Unit works fine, until system is shut off. Then device is not seen. Motherboard MS6309 and mfg recommended update BIOS, done, also update USB device (VIA Tech3038 PCI to USB bus)done from VIA patch. System will see printer upon boot, load drivers, software install sees printer, works fine .... until system shut down and restart next day. Slightly irritating to have to reset port everyday and wonder why system won't hold port assignment. Any suggestions?

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by djent In reply to USB port to label printer

Faulty USB connections? Try contact cleaner and or new cable.

Collapse -

by BarryVG In reply to

Poster rated this answer.

Collapse -

by carlos.nino In reply to USB port to label printer

Make sure that our USB drivers are for XP. Seems more a matter driver conflict.

Collapse -

by BarryVG In reply to

Poster rated this answer.

Collapse -

by BarryVG In reply to USB port to label printer

This question was closed by the author

Back to Hardware Forum
5 total posts (Page 1 of 1)  

Related Discussions

Related Forums