Windows Forum

Ask something
Discussion Locked

Using Fax in Windows XP

0 helpful
4 replies

by jbryan

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When I tried to use the fax loaded in windows XP the telephone lost it's dial tone and I had to disconnect my phone line to the modem to re-establish my phone's dial tone. I use a 512 LAN to get on the internet and I'm not really sure how to configure the fax to use a phone line.

Any ideas on how to set up the fax so it will work correctly.

4 replies

by jbryan

Good as far as it goes however it did not solve problem. I added four lines of code to regrister to solve problem.

by jbryan

The fax would not show any messages being sent or received and no indication of them being received. until I made the following entries:

[HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Rpc\ClientProtocols]
"ncacn_np"="rpcrt4.dll"
"ncacn_ip_tcp"="rpcrt4.dll"
"ncadg_ip_udp"="rpcrt4.dll
"ncacn_http"="rpcrt4.dll"

by jbryan

be sure to save the orginal entry before you modify it in case the additional code doesn't solve the same problem I experienced. If the problem is not resolved or if it creates another problem because of your configuration you can detele the changes and reinstall the original codes.

This discussion is closed to new replies.