General discussion

Locked

Validating Users

By johnnow ·
I want to connect up to 3 laptops running Win 95 to a 3Com Office Connect 56k lan modem dialing into my Win NT 4 RAS. I have the 3Com configured with a valid user and password. My problem is when I logon from any of the laptops. I get unable to finddomain to validate user. I followed the defaults from 3Com. What am I doing wrong?

This conversation is currently closed to new comments.

6 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Validating Users

by DAN_HAMMOCK In reply to Validating Users

Do you have the correct DNS, WINS and gateway set on the laptops? Are you able to access other network resources or do you get disconnected?

Collapse -

Validating Users

by johnnow In reply to Validating Users
Collapse -

Validating Users

by mjervis In reply to Validating Users

Make sure your network settings are correct wins, dns, ip addressing, workgroup name and domain name. Also make sure your subnet is right we had the same problem when I looked over the configuration it was just a wrong subnet.

To check your ip address and subnet in win9x use run > winipcfg

Collapse -

Validating Users

by johnnow In reply to Validating Users
Collapse -

Validating Users

by ihshaikh In reply to Validating Users

try pinging you NT server, it you do not get a reply, then your ip add, subnet, gateway, must be incorrect.

if you can ping then your network settings, wins, dns, domain should be looked into.

Collapse -

Validating Users

by johnnow In reply to Validating Users
Back to Windows Forum
6 total posts (Page 1 of 1)  

Related Discussions

Related Forums