General discussion

Locked

VLAN catalyst 2950

By elmer.rivera ·
Hi all,

im trying to configure vlan on my switch, port f0/1 is set as trunk, connected to cisco router. on my switch, port f0/2 & f0/3 belong to vlan2, and f0/4 & f0/5 on vlan3, all the others are vlan1 (default). servers on port 2 & 3 see each other, and so with port 4 & 5, however, going out to the router doesnt work. i tried pinging an outside ip but it says destination unreachable. port f0/1 (trunk) has been allowed (which i know allows all by default). the cisco router port (where the switch is connected) is configured with secondary ip addresses. primary ip for vlan2 and secondary ip for vlan3.

am i missing something? are there additional configuration on my router to be done?

TIA,
etcbin

This conversation is currently closed to new comments.

2 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by Nico Baggus In reply to VLAN catalyst 2950

You need to set the router to accept a dot1q
trunk (assuming you use dot1q and not ISL) on
its port.
This is a feature at the MAC layer, not IP
layer.
Then You can create VLANx interfaces for you
VLAN1 and VLAN2, with eacht their own address.

HIH,
kind regards,

Collapse -

by mshavrov In reply to VLAN catalyst 2950

Here is the link with an example, how to configure the router to do VLANs routing.

http://www.cisco.com/en/US/products/hw/routers/ps221/products_configuration_guide_chapter09186a008007cd23.html

Also there are some limitations for the router/switch. Originally 802.1q was supported only on 100 MBit interfaces. I heard some IOS releases were able to do same things with an old routers, but I'm unsure.

Good luck,

Mike
----
http://www.headsetadapter.com

Back to Networks Forum
2 total posts (Page 1 of 1)  

Related Discussions

Related Forums