Discussion Locked

Want to change my netwrok mask

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Network with 2 subnet: 192.168.10.0,192.168.0.0
Have one PDC:192.168.10.4
one BDC:192.168.10.8,192.168.0.8

Now I want to change these two subnet into a bigger one with the netmask: 255.255.254.0

should I reinstall these two Domain controllers,or is there anything I should pay attention to?

Any assistance is appreciated.

7 replies

by blkline

I don't think you'll have to reinstall the domain controllers. NetBEUI is independent of the TCP/IP setup -- by that I mean that NetBEUI over TCP/IP (which is what I assume you're doing) will work just fine even after you change the TCP/IP settings;this because the authentication and credentials that Windows uses is independent of the IP settings. It uses TCP/IP as a routable transport but the machines identities are not tied to the IP address. Once the machines come on line with the new IP addresses and the PDC/BDCs see them at their new locales then everything should work as before.

At least that has been in my experience...

by arjun_allah

no all you need to do is reconfigure your your network mask to be able to support to your new mak

by gurinder_bhinder

No need to re-install any thing. Just change the IP addresses of the systems in the network.

e.g.
Ip address of PDC : 192.168.yyy.1
Ip address of BDC : 192.168.yyy.2
Ip address of Clients : 192.168.yyy.3,4,5,6,7,8 and so on.

Subnet mask will be 255.255.254.0 for all.
No need of Default gatway because you want only one subnet.

Note:- U can also use DHCP server to take care of the addresses automatically.

This discussion is closed to new replies.