Discussion Locked

What is the syntax for SYSPART

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

What is the syntax for SYSPART
I am trying to create a partial 2000 server installation on a on a slave hard drive. I am using WINNT32 with a SYSPART switch

Here is how I am set up

? C: drive has 2000 server on it
? E: drive is a slave drive
?I have a 2000 server install CD in the CD Drive
?I have an answer file in the floppy drive ( unattend.txt)

From a CD Drive command prompt D:, I am trying to execute WINNT32 with a SYSPART switch. This is suppose to create a partial installation of 2000 server onto the slave drive. Does anyone know the exact Syntax to use for executing a WINNT32 /u:a:\unattend.txt /syspart so that the slave drive will have a partial 2000 installation?

Any references would be appreciated

5 replies

by beermonster

Hi,
Check out technet articles Q241803 and
"MS Windows 2000 Guide to Unattended Setup"

Both of which cover the syspart switch. Search for them at microsoft.com/technet

by mrjay67

Its also possible if you are actually doing this from a DOS/win98 boot up that you need to run WINNT instead of winnt32 which is reserved for inside windowsNT. If you are in Windows at a command prompt and your cdrom=D try running from d:\I386\. If the problem lies with your switches than I can only suggest trying the previous answer as im quite rusty with the switches.

Hope this helps...just wanted to add my 2 cents.

Jason

This discussion is closed to new replies.