Discussion Locked

Wierd graphic card fault?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi everyone,

I have fitted an existing hard drive into another machine, obviously they have different motherboards, everything was O.K. until I found the graphics card only showed 16 colours, I installed the correct drivers for it off the supplied CD and it still would not work, I took out the original video card out of the machine that the hard drive came from and installed that, still no Joy.

Can anyone shed any light on how I can get around this problem, I have removed the card in Device manager and installed a new video card (sis chipset) and this new card will not configure. The new motherboard is a QDI advance 9. The old motherboard was a jetway 542.

Thoroughly Pissed off Pete

Ta in advance.

5 replies

by geroxx

It sounds like you have a problem with windows not knowing that it is working on a new MB. When ever you swapp a HD from one MB to another you risk this type of thing. There are 2 ways to deal with it.

1. Make sure you have all of the drivers for the new MB and Video card along with you windows CD. Go into the Device Manager and remove the Video Card and the System Sources ( Esp. All PCI/APG BUS entries). Do not restart until you have everything deleted because after you remove anythingyou will be prompted to restart windows. Answer NO until you have everything removed. Then Restart Windows. It should now go through an find new bus mastering hardware.

2. The other way is the one I usually use. Backup data.... Format....Reload. It is the best way as it starts from scratch and you won't have some old hardware driver or window registery hosing you later.

HtH
Gary

by roberwel

Try this
Boot into safe mode. Go into device manager and remove any listing under display adapters, then reboot into normal mode. This will force windows to redetect the video card.
What happens is that windows gets confused about which driver touse so it automatically defaults to a standard vga setting.
If you want to avoid more problems, when you are in safe mode remove everything in device manager and reboot then windows will redetect everything.

This discussion is closed to new replies.