Discussion Locked

Win2K peer to peer connection

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am running 3 Win2K computers on a p2p network. IP address assigned 192.168.100.30 subnet 255.255.255.0 the other two with the same subnet and IP addresses end with 31 and 32. The Nics and cables are working ok, but I cannot see other computers inneighborhood. I ping each machine from the other and no response. can anyone assist me to connect these machines?

6 replies

by mike jones

Is the built in firewall blocking the traffic or do you have other third party firewall software installed.

Disable all firewall software while testing.

Double check that you can ping the loopback address, 127.0.0.1.

by dave.osborne

Is file and print sharing enabled for each of the three computers? Is it running through a hub, switch, router? Are they all part of the same workgroup (most likely in your case) or domain? Is this setup for sharing an internet connection ... if so, can the PCs get to the internet (which I think might not be the case because you didn't say anything about a "gateway")? If you open up a command prompt, and type "ipconfig /all" what do you see on each of the machines? Are you sure the IP addresses and subnet mask are being assigned properly?

Make sure the file/print sharing is enabled, and in the TCP/IP advanced settings, that it is enabled over Netbios. After that and when you can ping the individual PC's from each other, then make sure they are part of the same workgroup / domain.

Hope this helps.

-Dave

by joemorgan1

What type of NICs are you using... 10Mbps 10/100Mbps? Check that they are hard set to their lowest capacity firstly until you get connectivity. So If they are 10/100 NICs, set them in the advanced properties for you adaptor in the link speed to be firstly 10Mbps half or full duplex then change upward when connectivity is achieved. I have found that when all else fails and it defies logic, the default settings are not good enough for the NICs. Also just to put your mind at ease ensure you have the latest drivers for your NICs.

This discussion is closed to new replies.